Gets ready to put contents into the e-mail body.
The write(), print() or println() can be used for writing the e-mail after calling this function.
To end writing e-mail, endMassage() is used.
email.beginMessage()
none
none
#include <SPI.h>
#include <Phpoc.h>
PhpocEmail email;
void setup() {
Serial.begin(9600);
while(!Serial)
;
Phpoc.begin(PF_LOG_SPI | PF_LOG_NET | PF_LOG_APP);
//Phpoc.begin();
Serial.println("Email Client Test");
// setup From/To/Subject
email.setFrom("from_email_address", "from_user_name");
email.setTo("to_email_address", "to_user_name");
email.setSubject("Mail from PHPoC Shield for Arduino");
// write email message
email.beginMessage();
email.println("Hello, world!");
email.println("I am PHPoC Shield for Arduino");
email.println("Good bye");
email.endMessage();
// send email
if(email.send() > 0)
Serial.println("Email send ok");
else
Serial.println("Email send failed");
}
void loop() {
}